Diamond Blemishes
A pit or void on the surface of a polished diamond, formed when an inclusion breaks out or is removed during cutting. GIA classifies cavities as blemishes. They can trap dirt and — in larger sizes on prominent facets — affect clarity grade and long-term appearance.
During the cutting and polishing process, a lapidary must decide how to handle inclusions that approach or intersect the planned facet surface. If an inclusion — a crystal, a feather, or a knot — breaks away as the polishing wheel passes over it, the result is a cavity: an opening left in the facet where the inclusion was. Cavities can also be deliberately created: sometimes a cutter chooses to grind out a surface-reaching feather to prevent further propagation, leaving a controlled pit rather than an unpredictable fracture.
The shape of the cavity reflects what was there before: a crystal removal leaves a geometric-edged pit; a feather removal leaves an elongated trough; a knot removal leaves a roughly circular depression. Under 10× magnification, a gemologist identifies the cavity type from its shape and surrounding characteristics. The depth of the cavity matters for both the clarity assessment and for practical maintenance.
GIA weights clarity features by their visibility and impact from the crown (face-up) perspective. A cavity on the table — the largest flat facet at the top of the diamond — has maximum impact on both the clarity grade and visible appearance. A cavity on a small pavilion facet near the girdle has minimal face-up visibility and correspondingly less grade impact.
On the GIA grading report clarity plot, a cavity is shown as a red open circle (indicating a surface feature). The size is indicated by the symbol's proportion relative to the stone diagram. A large open circle near the centre of the table diagram is a meaningful feature; a small one near the diagram edge corresponds to a peripheral, minor feature. Always cross-reference the clarity plot symbol with the written description to understand exactly which facet is affected. See our GIA report reading guide for clarity plot interpretation.
A cavity is an opening or pit on the surface of a polished diamond. It forms when an inclusion — such as a crystal, a knot, or a feather — is either removed during polishing or breaks away, leaving a void. Unlike a scratch (a surface line) or a chip (a notch at the girdle or facet edge), a cavity is a three-dimensional opening into the stone's surface.
GIA classifies cavities as blemishes. On the GIA clarity scale, cavities can drag a stone's grade into VS2, SI1, or SI2 territory depending on size, depth, and location. A small cavity on a minor crown facet may result in a VS2 grade; a large cavity on the table will pull the grade toward SI2 or lower. The cavity is plotted on the GIA grading certificate and labelled accordingly. See our clarity guide for grade-by-grade evaluation.
Yes — this is one of the practical concerns with cavities. An open pit on the diamond surface can accumulate skin oils, soap residue, and dust. In deep cavities, cleaning with a soft brush and mild detergent usually removes deposits, but a very deep or undercut cavity can be difficult to clean thoroughly. A cavity on the table is more problematic for long-term appearance maintenance than one on a pavilion facet. See our ring care guide for cleaning advice.
No. A chip is a nick or notch at a facet edge, junction, or girdle — essentially where the surface edge has been damaged by impact. A cavity is a pit within a facet surface (away from the edges), formed by inclusion loss rather than impact damage. Both are blemishes on the GIA clarity scale, but they have different shapes, causes, and locations. See our blemish glossary for the full list of surface features.
It depends on size and location. A tiny cavity on a minor pavilion facet in a well-cut stone may be invisible face-up and offer a price concession worth taking. A large cavity on the table is a genuine issue for both appearance and long-term maintenance. Always check the GIA clarity plot for cavity location, ask for a loupe inspection or vendor imagery, and confirm the stone is eye-clean from normal viewing distance. Benchmark current prices at CaratAtlas (CC BY 4.0).